Norlys Lillehammer 2260AL outdoor LED wall light aluminium colour RAL 9006 2700 K DALI2

Norlys Lillehammer 2260AL is an outdoor LED wall light with a rectangular housing finished in aluminium colour RAL 9006. This version combines warm 2700 K light with DALI2 control. The body is powder-coated cast aluminium, with clear safety glass covering the light openings.

A narrow accent paired with a wider beam

The fitting emits light at 4° upwards and 60° downwards, or in the reverse arrangement. That contrast creates a narrow vertical accent alongside a more widely illuminated wall surface. When choosing its position, consider the space both above and below the fitting: the lighting effect extends beyond the outline of the housing. Beam distribution is therefore a useful distinction when comparing this version with other Lillehammer fittings.

The complete luminaire delivers 234 lm, while the LED module itself produces 1008 lm. The higher figure is not the amount of light leaving the finished fitting. Use the 234 lm luminaire figure when planning facade lighting. Its 2700 K colour temperature gives warm light rather than a neutral or cool appearance.

A compact, straight-edged wall fitting

The housing measures 18.5 cm high and 11 cm wide, projecting 8 cm from the wall. Compare those measurements with the mounting area and nearby architectural details before installation. Flat faces and clean edges, without decorative arms, support a modern, minimalist facade design.

Designed for exterior walls and facades, the fitting can also illuminate a wall beside a terrace or balcony. It has IP65 protection and an IK08 impact rating. Aluminium colour describes the coated finish of this particular version, not an untreated metal surface.

DALI2 control and professional installation

The luminaire consumes 7.6 W and operates on 220–240 V. It contains an LED module and an electronic DALI/TD driver; choose this version for an installation using DALI2 control. Two fixing holes are 5 mm in diameter, with 45 × 130 mm spacing. Installation must follow the manufacturer's instructions. Both the LED light source and control gear are replaceable by a professional service, rather than by fitting a conventional screw-in bulb.