NORLYS Lillehammer 2293GR outdoor LED wall light, graphite, 2700 K

NORLYS Lillehammer 2293GR is a graphite outdoor wall light that sends two exceptionally narrow beams upwards and downwards. Its rectangular cast-aluminium body is powder-coated in RAL 7016, with optical safety-glass covers at the light openings. The plain front and sharply defined edges suit modern, minimalist and Scandinavian architectural schemes.

Wall accents rather than broad illumination

Each beam has a 4° angle, making this version a choice for vertical lines of light on a façade rather than a wide wash across the surroundings. It can also accent a wall beside a terrace or balcony. When choosing a position, consider the available wall surface above and below the fitting. Roof overhangs and other projecting elements in either beam's path will affect the resulting light pattern.

The two LED modules produce warm-white light at 2700 K. Norlys specifies 1008 lm for the light sources but 28 lm for the complete luminaire. These figures describe different stages of the optical system: the latter is the light that actually leaves the fitting. Lillehammer 2293GR should therefore not be planned as a substitute for broad illumination of a driveway or circulation route.

Dimming and source replacement

The fitting consumes 7.3 W and supports trailing-edge phase dimming. If brightness control is required, choose a control system compatible with that method rather than assuming that any dimmer will work. Both the LED modules and the control gear can be replaced by a professional service technician. This is not a fitting for a conventional user-replaceable bulb.

Size and outdoor installation

The dimensions are 18.5 × 11 × 8 cm. Compare them with the intended mounting area and check how both beams relate to nearby architectural details. IP65 provides dust-tight protection and protection against water jets, while IK08 is the stated mechanical impact rating.

The supply is 220–240 V, with a protective-earth connection required for Class I. Mounting uses two 5 mm holes with a 45 × 130 mm spacing. Installation must be carried out by a qualified installer following the manufacturer's instructions, including correct treatment of the silicone seal and EPDM cable gland.