Gea Luce GFA1923N Recessed LED Light, Satin Black, 3 W, 4000 K, IP65

Gea Luce GFA1923N is a small recessed LED fitting with a square frame and a round light opening. Its aluminium body has a satin black finish, while the clear diffuser is made from methacrylate. It provides a black lighting detail close to the mounting surface rather than a suspended body on a cable.

A narrow beam with neutral white light

The integrated 3 W LED module delivers 240 lm at 4000 K. Its neutral white light is directed through a 24° beam, concentrating illumination on a limited area instead of spreading it widely to either side. When planning general lighting, consider the spacing of the fittings together with the other light sources in the room.

A CRI >90 is relevant when viewing the colours of objects and materials. It does not turn the narrow beam into broad illumination of the whole room. This fitting uses simple on/off operation and is not dimmable, so it is intended for a lighting arrangement that does not require continuous brightness adjustment.

An included LED module and separate transformer

The light source is built in, so there is no separate screw-in or push-in bulb to select for this fitting. The manufacturer also includes the transformer, but it is not integrated into the body. Allow space for this separate component when preparing the installation, not just for the visible square frame.

The supply specification is 220–240 V AC at 50/60 Hz. The assembly instructions require installation by qualified personnel and isolation of the mains supply before work on the fitting. Its small visible face should therefore not be treated as the complete installation footprint.

Bathroom and outdoor use

The manufacturer explicitly permits bathroom and outdoor installation, and specifies IP65 protection. In a hallway, living room or covered terrace area, the focused beam can form one point within a larger lighting layout. The simple black square frame suits modern and minimalist compositions.

For cleaning, the instructions specify a damp cloth with mild detergent, followed by gentle drying with a soft cloth. Cables and electrical components must not be exposed to water or detergent.