NORLYS Nora 2465CG LED outdoor wall light, cement grey, 2700 K, DALI2

NORLYS Nora 2465CG is an outdoor wall light with a flat square front and light directed both upwards and downwards. Its cement-grey finish is specified as RAL 7033. The body is powder-coated cast aluminium, with transparent safety-glass covers over the light openings. This is the clear-glass version, not a frosted-cover fitting or a light that takes a separately purchased bulb.

A small front with two-way distribution

The front measures 13 × 13 cm and the body is 5 cm deep. Compare those dimensions with the available mounting area and nearby façade details. The housing occupies a compact section of wall, while diffused light leaves it above and below. That two-way distribution is intended for lighting wall surfaces rather than concentrating the entire output into one spot.

The undecorated front and geometric proportions support modern, minimalist and Scandinavian settings. Consider it for a façade, an entrance area, a terrace or a balcony, provided there is a suitable surface for wall mounting. Its IP65 rating applies to the fitting when installed correctly in accordance with the manufacturer's instructions.

Warm light and DALI2 control

Two integrated LED modules produce a colour temperature of 2700 K. The complete luminaire delivers 745 lm at 10.3 W. That output is for the whole fitting, not each module, so it should not be doubled. The light sources and electronic driver are included; there is no separate bulb or socket type to select.

The 2465 version supports DALI2/TD control. Check the intended controls and wiring with your installer before ordering. The manufacturer specifies professional servicing for replacement of the LED modules and control gear, rather than a household bulb-change procedure.

Preparing the wall connection

This Class I fitting requires a protective-earth connection and a 220–240 V supply. It uses two mounting holes, each 5 mm in diameter, spaced 63 × 112 mm apart. Fixing plugs are not supplied and must be selected for the substrate. Installation should be carried out by a qualified person, following the instructions for the silicone seal and correct cable entry to preserve the enclosure's protection.