Outdoor Wall Light NORLYS Nora 2483CG Cement Grey LED IP65

NORLYS Nora 2483CG is a compact square outdoor wall light. The body is powder-coated cast aluminium in cement grey RAL 7033, with a transparent safety-glass cover and a silicone gasket. The face is a flat plate without ornament. Light leaves through openings above and below the housing, not through a decorative shade in the centre. It is the cement-grey 2483CG, not graphite, black or corten.

Wall mounting

The fitting measures 13 × 13 × 5 cm. It fixes to the wall with two 5 mm holes spaced 63 × 112 mm, Protection class I means the circuit must include a protective earth. Supply is 220–240 V at 50/60 Hz. The terminals accept cable up to 3 × 2.5 mm², loop-through up to 3 × 1.5 mm², and a round sheath of 7–10.5 mm. Installation and later service are for a qualified electrician. Net weight is 0.85 kg and gross weight is 0.91 kg. The carton measures 16 × 14 × 5.5 cm.

The light it produces

Two integrated Cree LED modules are already fitted, so no separate lamp is required. Rated luminaire power is 15 W and rated output is 1043 lm at 2700 K, CRI 80 and SDCM 3. The card states an efficacy of 69.5 lm/W. Distribution is diffused both upward and downward, with an upward light ratio of 50 percent, so the wash sits on the wall above and below the fitting. A switch on the driver sets power from 10.9 W to 15 W. The factory position is 10.9 W, so output after installation can stay below the 1043 lm rating until that switch is changed. Dimming is phase-cut, both trailing edge and leading edge. The LED module and the control gear can be replaced, but only by professional service. The light source is energy class D.

Where it belongs

The manufacturer card specifies lighting of wall surfaces, façades and other architectural schemes. IP65 means the housing is dust-tight and protected against water jets, It is an outdoor wall light, not a drive-over or submersible fitting. IK09 is the impact-resistance class. The stated ambient range is −20 °C to +45 °C, with a rated ambient of +25 °C. Condensation inside the housing can occur, and the maker treats it as normal rather than a defect. The unornamented geometric plate is minimalist.