TK-Lighting SENA L 19003 LED garden bollard, graphite, 80 cm, 3000 K, IP65

TK-Lighting SENA L 19003 is a graphite garden bollard with a narrow cylindrical body and a recessed light opening beneath its top cap. Its frame combines aluminium and plastic, while the transparent shade component is glass. The absence of decorative arms or an exposed lantern frame gives it a modern, minimalist profile.

An 80 cm light point beside paths

The L version stands 80 cm high and measures 10.5 cm in both width and length. It is a low-level lighting point rather than a tall garden lantern. Before choosing its position, compare that height with planting and nearby landscaping features to establish where the light opening will sit in your layout.

The manufacturer's detail photograph shows a round foot with mounting holes. The SENA family is intended for gardens, terraces, paths and driveways. Position the bollard outside walking or vehicle routes rather than within the usable passage. Its slender body creates a vertical marker, while the graphite finish and limited detailing suit an exterior organised around simple lines.

Warm white light below the cap

The LED light source is included, so there is no separate bulb to select. A colour temperature of 3000 K gives warm white light. The official illuminated photograph shows light emerging beneath the upper cap and falling down beside the body, rather than a shade that glows around its entire circumference.

The declared luminous flux is 150 lm. Treat this as a local light point when planning the layout, not as a promise that one bollard will illuminate an entire driveway. The number and spacing required depend on the actual area. SENA L is not dimmable, so a conventional dimmer is not a means of adjusting its brightness.

Supply and outdoor protection

This fitting requires 230 V, 50 Hz and is Class I, meaning a protective earth connection is required. It has no built-in power switch; switching must be considered as part of the installation. IP65 denotes protection against dust and water jets, not suitability for immersion. The manufacturer specifies a three-year warranty.