Zambelis 2083B-1 trimless recessed magnetic track, 48 V, 1 m, sandy black Promo Code - ZAM10 until the end of Oct 30

Zambelis 2083B-1 is a one-metre aluminium magnetic track made for trimless recessed installation. Its sandy black finish defines a narrow, deep channel for lighting modules, while the side wings are incorporated into the finished ceiling surface.

Plan the track before finishing the ceiling

The profile measures 7.4 cm across and 5.4 cm high; the section drawing identifies an internal width of 23 mm. Compare these measurements with the ceiling construction and intended opening before completing the surface. This is not a surface-mounted rail to screw onto a finished ceiling. The installation guide shows the profile being recessed, secured and plastered around its edges.

Once installed, the black channel remains the principal visible feature. Its straight outline and lack of an external frame suit contemporary and minimalist interiors where the lighting follows the ceiling layout. That appearance depends on planning the recess and finishing work, rather than simply choosing a track length.

A component of the 48 V magnetic system

The track belongs to the Zambelis 48V Linear Magnetic System and contains no light source itself. A working installation needs compatible magnetic luminaires, a power feed and a suitably selected 48 V power supply. Brightness, colour temperature and control options depend on those other components; the rail alone does not determine them.

The manufacturer specifies indoor use and IP20. For a living room, corridor or office installation, decide the position and lighting performance of the luminaires separately. The room photographs illustrate complete system layouts, not the contents supplied with this individual track.

End caps and corners for this profile

The documentation identifies the black 2099-B end cap and 20107 PC cover. The vertical 90° corner is 2083B-C1 and the horizontal corner is 2083B-C2; their electrical connections require 20105 and 20104 respectively. Select these parts to match the intended route. Installation instructions require power to be disconnected during work and the safety latch to be checked after each luminaire is fitted.