Nordlux Fremont LED recessed downlights, 3-pack, 4000 K, brushed steel

Nordlux Fremont 2310056032 is a pack of three recessed LED downlights in a brushed steel finish. A round metal trim surrounds the recessed reflector, leaving only a small part of each fitting visible against the ceiling. The construction also includes plastic components. These are separate ceiling fittings rather than a single surface-mounted light.

Plan three directed pools of light

Each downlight has an integrated, non-replaceable LED source rated at 4.5 W and 380 lm. Those figures refer to one fitting, not the complete three-pack. Its 4000 K colour temperature differs from warm 2700 K lighting, so consider that difference when combining Fremont with existing lights. Colour rendering is rated at Ra 80.

The 36° beam and tilting light section let you direct the light towards a chosen area. Position the three cut-outs around the surfaces you want to illuminate instead of treating the pack as one wide-beam ceiling light. Brightness can be adjusted continuously through a suitable wall-mounted dimmer. The integrated source means there is no conventional replacement bulb to select.

Check the ceiling cavity, not just the trim

Each fitting is 8.5 cm in diameter and 5.4 cm high. The installation drawing specifies a 72 mm cut-out in a 5–15 mm thick panel, a cavity height of at least 68 mm and at least 50 mm side clearance. Compare these requirements with your ceiling construction before ordering. The fittings must not be covered with thermal insulation or installed directly into insulation.

Bathroom use with protected rear connections

Nordlux confirms bathroom suitability. The room-facing side is rated IP65, while the section above the ceiling is IP20 and must remain protected from water. Connection to the 220–240 V mains is permanent. The instructions allow parallel connection of up to 15 fittings.

The simple circular trim and brushed finish suit modern living rooms, bedrooms, kitchens and circulation areas, or supplementary lighting in hotels and restaurants. Spacing and additional lighting should be planned for the room rather than assumed from the pack size. When the non-replaceable LED reaches the end of its life, the whole fitting is replaced.