The Q-VITO 8410-55 is a ring-shaped pendant lamp 40 cm across, finished in steel colour. The ring hangs on three thin cables below a round ceiling rose, and the light leaves through a diffuser strip on its inner edge. The source is a built-in LED module — there is no lampholder and nothing to replace.
How big it is and how low it hangs
A ring 40 cm across keeps its proportion over a table 80–90 cm wide. Maximum suspension is 120 cm and is shortened at the cables — usually so that the lower edge sits 70–80 cm above the tabletop.
The fitting weighs 1.46 kg. The maker states insulation class II, so no protective conductor is needed at the box, and IP20, which limits mounting to dry rooms.
How much light it gives and in what colour
The whole fitting draws 33 W. The maker publishes two flux figures: 3250 lm is the output of the LED module alone, while 1150 lm is what actually leaves the diffuser. The second is the one to plan a room around — roughly what a 75 W incandescent used to give.
Colour temperature is adjustable between 2700 and 5000 K, from warm, slightly yellow white to cool daylight white. The same fitting can therefore be set to cool light in the morning and warm light in the evening without swapping anything.
How it is controlled
An infrared remote is included, and it sets both brightness and colour temperature. Dimming happens electronically in the built-in driver, not through a wall dimmer.
The fitting has a memory function: after the mains is cut and restored it returns to the last setting. The maker also describes it as smart-home ready.
Add your comment about Q-VITO Pendant Lamp 8410-55 Steel LED Ø 40 cm with Remote