Black and amber Candellux NORDIC 22-55194 wall light 2 × G9 LED 5 W 77 cm

Candellux NORDIC 22-55194 is a tall wall light with a black lacquered-steel base and two amber glass shades. It measures 77 cm high, 15 cm wide and projects 8 cm. Two separately purchased G9 LED lamps up to 5 W point in opposite directions, forming a vertical accent on the wall.

Two glass shades on a vertical axis

The elongated, tapered shades are placed one above the other and point in opposite directions. Each is approximately 35 cm long and 8 cm in diameter according to the drawing. Amber glass warms the unlit appearance and can modify the perceived colour of the bulb. The vertical arrangement suits a mirror, console, sofa or bed, but check that its 77 cm height cannot conflict with furniture, a door or a circulation route before drilling.

Two replaceable G9 LED lamps up to 5 W

Each shade accepts one replaceable G9 LED up to 5 W, with neither source included. Colour temperature, output and CRI can be selected, although both lamps should match so the upper and lower sections look consistent. Check physical length because G9 products vary in size. Dimming requires two dimmable lamps and a compatible control. Never exceed the manufacturer's maximum wattage even if a physically compatible higher-power source fits.

Black steel and amber glass

The official variant specifies a black base and amber shades, which is more precise than the generic stored brown colour. Lacquered steel supports the vertical composition, while decorative glass requires careful cleaning. The complete fitting is 15 cm wide and projects only 8 cm. Stored weights are 0.64 kg net and 1.12 kg gross. Its only existing image is the accurate dimension drawing, so no artificial supporting image has been assigned.

230 V, IP20 and safe installation

NORDIC operates at 230 V and belongs in a dry interior; IP20 provides no water protection. Level the approximately 13 cm-high base on a load-bearing wall and select anchors for the substrate. Locate hidden wiring, isolate the circuit before drilling and protect glass shades from impact. A qualified electrician should complete fixed wiring. Replace lamps only after cooling and power isolation, supporting the glass without excessive pressure while accessing each G9 holder.