LED Labs PRO B 4-pin connector for 10 mm RGB/CCT LED strips with 15 cm cable

LED Labs PRO B 24-0000-46 is a single-ended connector with a cable for 10 mm RGB/CCT LED strips. This version has four contacts and a pre-attached 15 cm cable. Its transparent body is made from polycarbonate, with copper conducting elements.

Match the strip and allow space for the body

This connector provides a transition from an LED strip to a cable rather than joining two strip ends directly. Check the 10 mm strip width and compatibility of the four contacts before choosing it. RGB/CCT is the designation used in the manufacturer's documentation; this is not the six-pin RGB+CCT version.

The body measures 22 × 14 × 7 mm. Those are the connector dimensions, not the width of the compatible strip, so use them when checking the space available at the connection. The cable has four conductors, each with a cross-section of 0.3 mm². Its 15 cm length defines the reach of the attached lead.

Solder-free connection and electrical limits

The contact pins pierce the strip's PCB, and the body closes with a click-fit mechanism. Connecting the strip therefore does not require soldering. The manufacturer specifies 5, 12 and 24 V DC operation and a maximum current of 2 A. Match the voltage and circuit load as well as the contact arrangement.

The connector can be used with IP20 and IP65 strips, but an IP65 connection must be sealed to maintain that protection rating. Connecting an IP65 strip does not, by itself, seal the joint.