Lumines LED PRO C is a two-sided connector with a 15 cm cable for 10 mm RGB/CCT LED strips. Its four PCB-piercing pins join two strip sections without soldering, so it is an installation component rather than a light source.
Strip compatibility
The connector uses a 4-pin layout and operates at 5, 12 or 24 V DC. Before fitting it, compare the strip width, contact count and RGB/CCT function with these requirements. This version is not intended for single-colour strips or RGBW strips.
Cable and construction
The polycarbonate body with copper contacts measures 22 × 14 × 7 mm. Its 4 × 0.3 mm² cable creates a 15 cm separation between the connected sections. The manufacturer specifies a maximum current of 2 A.
Installation note
An opener is supplied to access the clamp. The connector can be used with IP20 and IP65 strips, but the connection itself must be sealed to retain IP65 protection. Check the voltage and load of the complete installation before switching it on.
Add your comment about Lumines LED PRO C two-sided connector with 15 cm cable for 10 mm RGB/CCT LED strips