MEAN WELL HDR-30-24 DIN-rail power supply 24 V DC 36 W IP20

MEAN WELL HDR-30-24 – 24 V DC DIN-rail power supply

The HDR-30-24 is a compact switching power supply for DIN-rail installation where a stable 24 V DC output is required. This version delivers up to 1.5 A with a rated output of 36 W. As part of the slim HDR-30 range, it is intended for control cabinets and installations in which every module position matters.

The HDR-30 designation identifies the series, while the exact HDR-30-24 variant is defined by its 24 V and 1.5 A output. A visually similar version with another output voltage is not an interchangeable replacement. Allow room for correct conductor routing and safe access to the terminals when planning the enclosure layout.

Key electrical and mechanical data

• 24 V DC output, up to 1.5 A;
• 36 W rated output power;
• 85–264 V AC universal input, 47–63 Hz;
• 35 × 90 × 54.5 mm housing;
• mounting for TS-35/7.5 or TS-35/15 DIN rail;
• IP20 enclosure rating.

A practical choice for control equipment

The 35 mm-wide housing helps keep a distribution board or control panel orderly without taking unnecessary rail space. It can support building automation, industrial control, factory automation and similar equipment supplied at 24 V DC, provided the combined load remains within the model’s output rating. A built-in LED indicates that power is present.

Plan the circuit around the actual load

MEAN WELL specifies short-circuit, overload and over-voltage protection for this unit, along with adjustable DC output voltage. Before installation, check the voltage requirement, total current draw and power margin of every connected device rather than selecting a supply by nominal voltage alone. Mains-side wiring and installation should be completed by a qualified installer in accordance with the manufacturer documentation and the requirements of the finished system.