Lillehammer 2294WH is a white NORLYS outdoor wall light in the form of an 18.5 cm tall rectangular block, made of cast aluminium powder-coated in white (RAL 9003). Light leaves only through the bottom, through safety glass, in a narrow 4° beam.
What light it gives
The integrated 2700 K LED module gives warm, slightly yellow light. The manufacturer states 504 lm for the source and 14 lm for the whole fitting: the narrow optic sends the light downwards as a strip along the wall below the fitting. This is an accent light that draws a line of light on a facade, not a lamp for lighting a driveway or terrace.
ULOR is 0%, meaning no light escapes upwards, which is why the fitting is marked as dark-sky friendly.
Mounting and connection
The wall light is 18.5 cm tall with an 11 × 8 cm cross-section and weighs 1.57 kg. It is fixed to the wall through two ø5 mm holes spaced 45 × 130 mm apart.
The terminals take conductors up to 3 × 2.5 mm², and the fitting can be looped through with up to 3 × 1.5 mm², so several wall lights on one facade run from a single supply line. The EPDM gland takes a round cable of 7–10.5 mm diameter. The fitting is protection class I, so it needs an earth connection, and installation should be done by a suitably qualified person.
Supply, dimming and service
The electronic driver is built in, so the wall light connects directly to the 230 V mains. The manufacturer specifies trailing-edge phase dimming, so when choosing a dimmer you need to check that it works in that mode.
The LED module is replaced by a professional service, while the driver can be replaced by the user; the manufacturer offers service kit ZS2294zx0009 for this fitting. The driver lifetime is given as 50,000 hours.
Durability and use
IP65 means a dust-tight housing protected against water jets, and IK08 describes the housing's impact resistance. The manufacturer intends the fitting for lighting wall surfaces, facades and architectural details.
