KLUŚ LIGER-11 B17037S_2 is a satin polycarbonate cover for compatible LED profiles. Its flat face covers the LEDs and diffuses their light. This version measures 2005 mm in length and 12.4 mm in width.
Match the cover to the profile
The cover snaps into a profile designed to accept it. A similar width on another channel does not establish compatibility: the connecting geometry must also match. The LIGER-11 family documentation lists profiles including MICRO-NK, MICRO-PLUS, PDS-NK, PDS-4-PLUS, KUBIK-45 and LIT-L. Check the exact profile designation when specifying a new assembly or replacing an existing cover.
This is a lighting-system component, not a complete luminaire. Select the LED tape and other assembly parts using the documentation for the chosen profile. A photograph of a completed installation does not establish the technical rating of the cover itself.
Satin diffusion and a line of light
KLUŚ specifies 59% light transmission for the satin version. This figure describes the cover rather than the luminous flux of an assembled fixture, and distinguishes it from the black cover in the same family. LIGER-11 is intended for creating a line of light, and the manufacturer also recommends it for bent profiles.
Use the stated 2005 mm length when comparing this cover with a profile described nominally as two metres long. Final alignment and preparation of the sections should follow the planned KLUŚ system rather than rely on the abbreviated “2 m” designation alone. The same dimensional check matters when selecting a replacement for an existing installation.