Lumines H left silver ABS end cap with push-out hole 12-0000-43

This is the left ABS end cap for the Lumines H LED profile, in silver, code 12-0000-43, EAN 5907775757878. It closes one end of the profile. It is not the aluminium profile, a diffuser or an LED strip, and this listing is one left-hand piece.

The manufacturer photograph shows the left and right silver ABS caps together, so the traced face opening and the rear tongue are visible. The right-hand cap, 12-0000-44, is not included. The H section is asymmetrical, with light leaving at 30° or 60° depending on which face sits against the furniture, so the left cap cannot be turned and used as the right one.

System H only

The cap belongs only to system H. Silver colour does not make it fit other Lumines profiles. On the official accessory table, 12-0000-43 is the plastic ABS cap with a push-out hole. The left silver aluminium cap with an already open hole is 12-0265-10, a different material and a different cable exit. The grey plastic left push-out cap is 12-0944-01.

The face follows the H cross-section on the Lumines datasheet. The outer dimensions of that section are 16.9 mm and 16.6 mm; the drawing also carries the internal marks. Those figures describe the profile, not the cap thickness or the cable-opening diameter. Compare an installed cut end with that drawing before ordering a cap from another system.

A tongue on the rear enters the profile end. The catalogue records this as a press-in cap, and screws are not listed with this code. The CH metal clip, a diffuser such as BASIC, and an LED strip up to 12 mm wide are sold separately. H profiles come in 1000, 2020 and 3000 mm lengths, and to order up to 6 m.

Push-out cable opening

The traced opening stays closed until the marked area is pushed out, leaving a path for the supply cable through the profile end. Leave it intact if the cable will use the rear groove or exit elsewhere. That groove is part of profile H: it pulls the profile into a furniture or wall corner and can hide a small-diameter cable. It is not part of this cap.

Shelves, cabinets and corners

Profile H is specified for shelves and cabinets and for furniture or wall corners. It can be surface-mounted, and suspended mounting is also listed. The cap only closes the end of such a length. It does not emit light or change the 30°/60° direction. System H is unsealed, IP20 on the profile datasheet, and this cap does not make it an outdoor or bathroom fitting.