NORLYS Asker 1311GB grey-beige LED garden bollard 85 cm 3000 K

NORLYS Asker 1311GB is an 85 cm LED garden bollard with a rectangular body and a flat, projecting head. The GB variant has a grey-beige RAL 7006 finish on its powder-coated cast aluminium housing. It is designed for fixed outdoor installation rather than use as a movable floor lamp.

Downward light beside paths and terraces

Asker directs light down towards the area around the bollard. This makes it a candidate for lighting beside a garden path, at the edge of a terrace or along a private driveway. This version provides warm white light at 3000 K. The complete luminaire consumes 7.2 W and delivers 573 lm. The separate figure of 1030 lm describes the light source itself, not the output emerging from the assembled fitting.

When laying out several light points, consider the downward distribution and any obstacles around the surface to be lit. Spacing should follow the actual path layout, rather than be chosen from bollard height alone. This low fitting does not replace a tall lighting column illuminating a large area from above.

Dimensions and a simple architectural outline

The dimensions are 85 × 20 × 11 cm. Straight edges and the absence of decorative detailing give Asker a modern, minimalist appearance. Grey-beige is a distinct finish, not the black, graphite or aluminium-coloured version, so check the colour code when combining multiple fittings.

The transparent polycarbonate cover is textured and UV-stabilised. The construction also includes a silicone gasket. The manufacturer specifies IP65 protection and IK10 impact resistance; these ratings do not remove the need for a correctly designed electrical installation.

Fixed mounting and service requirements

Asker requires a 220–240 V supply and installation by a suitably qualified person. Its fixing uses four 8 mm holes with 18 × 50 mm spacing. Anchors, adapters and other mounting accessories are purchased separately to suit the installation surface.

The LED module and electronic driver form part of the fitting. It supports trailing-edge phase dimming, which must be considered when selecting the control equipment. Replacement of the LED source and control gear is intended for professional servicing, rather than an ordinary bulb change by the user.