22284 is a pendant-mounted supply base for the Zambelis 48 V magnetic system in its circular and curved form. The manufacturer calls it an On-Off Driver Box: a 100 W driver sits inside a 56.2 cm aluminium bar. The part itself does not light up — it is the point the track hangs from and the point it is fed from.
What is in the box and what you still have to buy
The set holds the housing with the 100 W On-Off driver, the 48 V feeder and a 200 cm cable. The rest of the system is down to the buyer: the 48 V magnetic track — circular or curved — and the light modules that clip onto it magnetically. Without them 22284 produces no light.
A hundred watts is the power budget for the whole circuit: the combined draw of every module on the track fed from here has to stay under it. Zambelis lists a 200 W counterpart in the same family under code 22286.
How big it is and where it goes
The bar is 56.2 cm long, 2.6 cm wide and 5.2 cm tall. It is a narrow profile fixed to the ceiling, so compare the room it needs with the spacing of the fixing points above the track circle you are planning.
It is made of aluminium in a black finish with a fine sandy texture — the same one Zambelis uses on the tracks of this system, so base and track read as one piece. The supplied cable is 200 cm, and that is what sets how far below the ceiling the track can hang.
Supply and control
The driver takes a mains supply of 220–240 V at 50–60 Hz and puts out 48 V, the voltage the whole magnetic system runs on.
Control is the On-Off version: the whole track is switched on and off with an ordinary switch, and this base does not vary the brightness of the modules. A dimmer does not belong on it.