NORLYS Asker 1726CS is an outdoor LED wall light with a rectangular, rust-coloured body. The manufacturer's Corten Steel designation describes the finish rather than the construction material: the housing is aluminium. A plain front face and an underside light outlet give it a restrained architectural shape.
Warm light directed below the fitting
The integrated LED module produces warm white light at 3000 K. The complete luminaire delivers 429 lm while drawing 5.4 W; this is the output leaving the fitting, rather than the output of the bare LED module. Its diffuse, hemispherical distribution is directed downwards, so consider the area below the housing when deciding where to mount it. This is not an up-and-down wall light.
Brightness can be controlled using compatible trailing-edge phase dimming. Check that control method when selecting a dimmer instead of assuming that any lighting regulator will work. The LED source and control gear can be replaced by a professional service. This is therefore not a fitting that takes an ordinary user-replaceable screw-in bulb.
Allowing space on the wall
The housing is 22.5 cm wide, 11 cm high and 8.5 cm deep. Compare these measurements with the available wall area or pillar width before drilling. Wall mounting and downward distribution make it an option for a façade, entrance, terrace wall or balcony wall, with the final position chosen around the surface that needs illumination.
IP65 protection and IK08 impact resistance support its outdoor purpose. Mounting uses two 4.5 mm holes with a specified spacing of 180 × 60 mm. This is a Class I luminaire, and installation should be carried out by a qualified electrician.
A rust finish on a simple aluminium form
The powder-coated cast-aluminium body is combined with a transparent, structured polycarbonate cover. Its undecorated rectangular form supports modern, minimalist and Scandinavian architectural schemes. The 1726CS finish adds a rust-brown accent without changing the straightforward geometry of the Asker family.
