Astrid 2202GR is a 55 cm NORLYS bollard light made from an extruded aluminium profile, powder-coated in graphite RAL 7016. The profile is a rounded square, 14 × 14 cm, with vertical fluting along its full height; at the top, light leaves through slots with an opal PMMA diffuser behind them.
The light it gives
The 8.2 W Osram LED module produces 1620 lm at 4000 K, neutral white, but 216 lm leaves the fitting – the opal diffuser and the slots in the profile hold back the rest. 216 lm is orientation-level light: it marks a path or the edge of a terrace but will not light a large area. The whole fitting draws 10.6 W, has CRI 80 and energy class C.
Control, servicing and lifetime
The built-in driver works on DALI2, so brightness is set from a DALI controller, not an ordinary phase dimmer. The LED module and driver are replaced by a professional service, and the manufacturer lists service kit ZN2202xx0009 for this fitting. Module life is over 70,000 h (L80B50) and driver life 100,000 h. Flicker of Pst LM ≤ 1 and a stroboscopic effect of SVM ≤ 0.4 are the limits EU ecodesign rules set for mains-powered light sources.
Height and installation
At 55 cm it stands 20 cm below the top of a dining table – a figure to compare with the plants that will grow beside the bollard. The base is fixed with three bolts through ø9 mm holes 120° apart on a ø65 mm circle. Concrete-in anchor 205, ground anchor 206GA, concrete foundation adapter 206S and mounting adapter 3080GA are sold separately.
The terminals take conductors up to 5 × 2.5 mm², also when looping on to further bollards, and the EPDM gland accepts round cable up to 12.5 mm in diameter. The manufacturer allows 46 fittings per circuit breaker at B10A, 74 at B16A and C10A and 119 at C16A. IP65 means a dust-tight housing protected against water jets, IK10 the highest impact resistance (up to 20 J), and protection class I that an earth connection is required.