Lutec CURTIS is a solar outdoor wall light with an anthracite aluminium frame surrounding an opal polycarbonate diffuser. Its solar panel sits on top, with the motion sensor below the diffuser, so the light needs no mains power cable run to its mounting position.
Solar power and space on the wall
The 1 W polycrystalline panel charges a 3.7 V, 1500 mAh battery. When choosing a position on a facade, terrace or balcony, consider sunlight reaching the top of the fitting as well as the area you want to illuminate. The manual recommends eight hours of charging in the sun. Operating time depends on the weather and on charging conditions during the day; it is not a fixed duration regardless of where the fitting is installed.
The body measures 19 cm high and 16.5 cm wide, projecting 9.5 cm from the wall. Compare these dimensions with the available space beside a door or near a corner before mounting. The plain, unornamented frame gives the fitting a modern, minimalist appearance. Its IP54 rating provides protection against dust and splashing water for outdoor use.
Warm white light without a separate bulb
The integrated 3 W LED provides 300 lm at 3000 K: warm white light for local illumination rather than a substitute for a powerful floodlight covering the whole garden. The light source is already part of the fitting, so there is no separate bulb to select. The manual states that the LED is not replaceable; at the end of its life, the complete luminaire must be replaced.
How the motion sensor works
In automatic mode, the PIR sensor becomes active at dusk and deactivates at dawn. Movement switches the light on for 45 seconds. Lutec specifies a 120° detection angle and a range of up to 12 m, illustrated in the manual at a mounting height of 2.5 m. The sensor is not adjustable, so account for the position of the passage relative to the fitting before fixing it in place.