NORLYS Astrid 2219CS LED garden bollard, rust brown, 55 cm, 3000 K

NORLYS Astrid 2219CS is a garden bollard with a vertically ribbed body and a square section with rounded corners. Its aluminium profile is powder coated in the finish the manufacturer calls Corten Steel, approximately RAL 8011. That designation describes the colour rather than the body material: this is not a bollard made from weathering steel.

A low light point beside outdoor surfaces

The 2219 version stands 55 cm high and measures 14 cm in both width and length. Compare these dimensions with the paving edge and nearby planting before installation so that the light-emitting section is not screened by vegetation. It can be planned into garden lighting, terrace edges or driveways. This is a low bollard rather than a tall lantern intended to illuminate a large area from above.

The repeated vertical ribs and simple top, without a decorative projecting arm, give Astrid a modern, minimalist appearance. Its restrained form also works with Scandinavian architectural styling, rather than reproducing the details of a traditional garden lantern.

Warm light and phase-cut control

A milky PMMA diffuser distributes light from the built-in 3000 K LED module. The complete luminaire delivers 272 lm; the LED source itself produces 2113 lm. These are different measurements. Use the luminaire output and its photometric information when planning spacing, rather than judging the installed light solely by module output or wattage.

Total luminaire power is 14.6 W, while the LED module is rated at 12 W. Astrid supports TRIAC phase-cut dimming using both leading-edge and trailing-edge control. Check that the chosen dimmer matches this control method. The LED light source and control gear can be replaced by a professional service, rather than through an ordinary user bulb change.

Fixed mounting and separately purchased parts

The bollard requires a 220–240 V supply and a protection-class I installation. Three 9 mm mounting holes are spaced at 120° on a 65 mm circle. Mounting screws and installation accessories are not included; select an appropriate anchor or adapter for the supporting surface. IP65 protection and IK10 impact resistance are confirmed for this luminaire, but do not replace correct installation by a qualified person or preparation of a suitable fixing location.