NORLYS Nora 2475CB LED outdoor wall light, copper brown, 4000 K

NORLYS Nora 2475CB is an outdoor LED wall light with a square front finished in copper brown, RAL 8004. The body is powder-coated cast aluminium, with satin safety glass over the light openings. The CB suffix identifies the finish: it does not mean that the body is made from copper.

A compact square with light above and below

The fitting measures 13 × 13 × 5 cm. Compare its face size and depth with the available wall area when choosing a mounting position. Its flat body and absence of decorative framing suit modern, minimalist and Scandinavian architectural schemes. The warm tone of the paint should not be confused with the colour of the emitted light.

Two LED modules distribute diffused light upwards and downwards. This is a wall-lighting distribution, rather than an adjustable spotlight that can be aimed at a particular object. The fitting can be used on a façade or on a wall beside a terrace or balcony.

Neutral white with DALI2/TD control

This 2475CB version delivers 4000 K light and a luminaire output of 643 lm at 15.3 W. When combining several fittings, compare their exact colour-temperature specifications: 2700 K and 3000 K versions produce a warmer white. LED modules and an electronic power supply form part of the fitting, so conventional screw-in bulbs are not required.

Lighting control uses DALI2/TD. Check compatibility with the proposed control installation before ordering, rather than assuming that the fitting works with any ordinary wall dimmer.

Installation and service requirements

The light connects to a 220–240 V supply and is Class I, requiring a protective earth connection. Its two 5 mm fixing holes use a 63 × 112 mm spacing. Fixing plugs are not included. The installation instructions specify a round cable with a diameter of 7–10.5 mm.

The IP65 rating depends on correct installation. The gasket must be pierced with the installation cable itself, not a tool that could damage the seal. Installation and replacement of the LED light source or control gear must be carried out by an appropriately qualified professional.