SLV NUMINOS DL XL 1004010 is a round recessed downlight with a black housing and a white inner ring. Its aluminium body contains an LED module producing warm white light at 3000 K. A separately selected constant-current driver is required: the downlight must not be connected directly to the mains.
Cut-out and ceiling space
The visible diameter is 16 cm, while the installation cut-out is 14.5 cm. These measurements serve different purposes: the first describes the outside edge, the second the hole to prepare in the ceiling. The body is 10.8 cm high, and SLV specifies an installation depth of 11.5 cm. Check the available space above the ceiling panel as well as the opening diameter before choosing the fitting.
The instructions specify a panel thickness of 7–25 mm. The fitting must remain ventilated and must not be covered with insulating material. Article 1004010 falls within the IP44 group identified in the manual, meaning protection against splashing water. It is for indoor use; bathroom positioning must comply with the applicable electrical installation rules.
Warm light in a narrow beam
The 3550 lm output is directed through a 20° beam, giving concentrated rather than widely spread light. This matters when highlighting a particular object or part of a room. The 3000 K colour temperature produces warm white light, while CRI 90 helps distinguish the colours of illuminated surfaces more faithfully than a lower colour-rendering index.
The LED module is part of the downlight, so there is no conventional screw-in bulb to select. SLV permits replacement of the light source only by a qualified professional.
A separately selected driver
The manual requires a constant-current driver with a 1050 mA output and a power rating of at least 37.4 W. The driver is a separate accessory. The specified cable distance between driver and downlight is 20–200 cm, which needs to be allowed for when arranging components above the ceiling.
Control options depend on the selected driver; the fitting itself is not a DALI device. Electrical connection must be carried out by an approved electrician.