BRICK DOWNUNDER is an outdoor recessed wall light with a rectangular silver-grey aluminium frame. The front is covered by horizontal louvres through which the light comes out, and the bulb itself cannot be seen from the front. Only the flat frame, fixed with four screws, stays on the wall surface.
Fitting it into the wall
The frame measures 22.7 × 12.5 cm, while the body sits in a rectangular opening of 19.8 × 9.7 cm with an installation depth of 6.5 cm. The overall depth is 8.5 cm, so the frame stands about 2 cm proud of the wall face. The opening and the box are prepared while the wall is built or rendered — these are the dimensions to pass on to the builder or façade contractor.
The light is protection class I, so it needs an earth conductor, and it runs directly on 220–240 V mains with no separate driver. The connection should be made by an electrician.
Which bulb you need
Inside there is one E14 lampholder for a small C35 round-shaped bulb of up to 40 W. No bulb is included. SLV recommends a clear C35 E14 LED bulb rated 4.2 W at 2700 K, a warm, slightly yellowish light.
Where it works
The IP44 rating means protection against water splashing from any direction, which is why the manufacturer intends the light for outdoor use; the manufacturer's photo shows it set into a retaining wall. Its IK02 impact rating is low, so it belongs where it will not be kicked or hit by garden equipment. The silver-grey aluminium housing sits well with concrete, stone and light-coloured render.