The Zambelis S148 is a round recessed ceiling downlight with an outer diameter of 9.3 cm and a height of 4.6 cm. The body is aluminium in a sandy white finish, and the insert holding the GU10 lampholder is movable, so the light can be tilted away from the vertical.
The hole to cut and the space to leave above the ceiling
The manufacturer specifies a mounting hole of 8.3 cm in diameter. The fitting's flange measures 9.3 cm, so it overlaps the edge of the hole by about 5 mm all round and hides an uneven cut in the board. The fitting is pushed into the hole and held in the ceiling by spring clips.
The fitting itself is 4.6 cm high, but the manufacturer requires a recess depth of 10 cm above the board — a measurement to check in a suspended ceiling before buying. No connecting cable is supplied: the 220–240 V supply is wired into a terminal block, and the instructions call for installation by an electrician. The fitting must not be covered from above.
The bulb and the kind of light
The GU10 lampholder is factory-fitted, but no bulb is included — you need one GU10 lamp of up to 40 W, inserted from below and held by a retaining ring. Colour temperature, brightness and colour rendering therefore depend entirely on the bulb you choose, which is why the manufacturer gives none of them for the fitting itself.
Dimming also depends on the lamp: it takes a bulb sold as dimmable and a dimmer that matches it. As a matched light source the manufacturer suggests the OSRAM COIN 50 G3 module, sold separately, with an on-off, DALI or phase-cut driver.
Aiming the light
The movable insert lets you aim the beam at a wall, a picture or a cabinet front without moving the hole in the ceiling. The manufacturer recommends keeping the lit object at least 0.5 m from the fitting. The same model in a black finish carries the code S149.