Francisca is a pendant light made from a ribbon of black, textured profile bent into two interlocking loops. A strip of clear, faceted acrylic runs along one edge of the ribbon — the integrated LED module shines through it, and the facets break the light into small sparkles. The fitting hangs on three thin suspension wires below a round black ceiling plate.
How big it is and where to hang it
The fitting is 55 cm in diameter — the figure to compare with the width of your table or the free space beneath the lamp. Overall height adjusts from 50 to 180 cm, and the cable is 1.5 m long. Over a table this lets you set the lower edge 70–80 cm above the tabletop, so the light covers the table without dazzling anyone seated, while under a low ceiling the lamp can be raised high.
The manufacturer intends Francisca for hanging above a dining table or as the main light in a living room.
How much light it gives, and what kind
The light source is a 42 W integrated LED with a flux of 2700 lm. That is main-lighting level rather than mood lighting — the lamp can light a table or the middle of a room on its own. 3000 K is warm white, slightly brighter and less yellow than a traditional incandescent bulb. The LED driver is included, so nothing else needs to be bought for it to work; the LEDs, however, cannot be swapped like a bulb.
The lamp is dimmable, but only with a trailing-edge (phase-cut) dimmer. When buying a dimmer, check its description to confirm it works in this mode.
Construction and connection
The design is modern: a flowing, asymmetric line with no ornament, where the only detail is the faceted acrylic edge. The body has a black, textured finish that contrasts with the clear acrylic — visible even when the light is off.
The fitting is protection class II, meaning reinforced insulation instead of earthing. It needs no protective earth conductor, so it can also be connected where the ceiling box has no earth wire.