Lillehammer 2262BL is a compact, box-shaped outdoor wall light in cast aluminium, powder-coated black (RAL 9005). Light leaves only through the bottom, through a clear safety-glass lens, and the LED module and driver are built into the fitting – there is no bulb to buy.
Size and mounting
According to the manufacturer's drawing the light is 18.5 cm high and 8 cm wide, projects 11 cm from the wall and weighs 1.6 kg. It is fixed through two ø5 mm holes on a 45×130 mm pattern. The cable gland takes a round cable 7–10.5 mm in diameter, and the terminals accept up to five 1.5 mm² conductors.
Fittings can be looped through, so several lights along one facade run on a single supply cable. The data sheet states how many fit on one circuit breaker: 46 on B10, 74 on B16, 74 on C10 and 119 on C16. It is protection class I, so it must be connected to the protective earth, and the manufacturer specifies installation by a suitably qualified person.
What light it gives
The light is directed downwards in a 60° beam, and ULOR 0% means nothing is emitted above the fitting. Drawing 4.5 W, it delivers 103 lm – roughly one eighth of an old 60 W bulb. That is light for grazing the wall below the fitting and marking an entrance, in line with the use the manufacturer gives: lighting walls and facades. 2700 K is a very warm, yellowish white, and CRI 80 is standard colour rendering.
The light is controlled over DALI2, so dimming requires a DALI installation with a controller. The five terminals leave room to bring the DALI control line to the fitting alongside the mains supply.
Weather resistance
IP65 means dust-tight and protected against water jets from any direction, so the light can hang on an exposed wall. IK08 is resistance to an impact of 5 J. The glass is sealed with silicone and the cable enters through an EPDM gland. The plain, unornamented body matches the Scandinavian, minimalist character of the Lillehammer range.
