LUMINES FLEXA SealFlow® LED set 24 V 30 W 3000 K IP68 anodised silver 3 m

LUMINES FLEXA SealFlow® 22-0101-75 is a complete 3 m linear LED set, rather than an empty aluminium channel. Its silver anodised profile contains an LED strip sealed in polyurethane resin. This version is rated at 24 V and 30 W; the 3000 K designation describes the strip before sealing.

Understanding the finished light colour

When matching this set to another lighting run, distinguish the original strip specification from the finished assembly. For strip 16-2389-01, the manufacturer lists an initial colour temperature of 3000 K and a value of 3819 K after sealing. The finished set should therefore not be assumed to match an unsealed 3000 K strip exactly.

The photometric table gives 522 lm for a 1 m section, with Ra 89 and R9 40. That flux figure belongs to the stated measurement length, not to the entire three-metre set. Keep the measured length in view when comparing it with other linear lighting products.

Included parts and cable routing

The package comprises the FLEXA profile, a PROFI 24 V 1000 LED 2835 SMD 10 W strip and black OMYp / H03VVH2-F 2 × 0.5 mm² cable. The datasheet specifies 2 m of cable at each end. Both exits pass through the rear of the profile, so their position matters when planning the supply route. The cable marking 300/300 V is not the operating voltage of the LED set.

A restrained architectural line

The manufacturer specifies surface mounting or suspended installation. Compare the full 3 m length with the intended lighting run and cable exit positions before choosing its location. The slim, undecorated construction suits modern and minimalist architectural schemes. SealFlow® sealing gives the assembly its declared IP68 protection rating; the installation must also account for the electrical connections rather than treating the profile rating as a specification for the whole circuit.