Nowodvorski CAMELEON CABLE GX53 7 m pendant cable with lamp holder, beige 12105 Promo Code 🚀- NOVO15 until the end of Oct 25

Nowodvorski CAMELEON CABLE GX53 7 M 12105 is a beige suspension component for the CAMELEON system, rather than a lamp with a large decorative shade. Its cable ends in a shallow circular lamp holder with vertical ribbing. Painted steel and plastic form the construction, finished in Beige P038.

Planning around the seven-metre version

The manufacturer specifies a height of 700 cm and a width of 8 cm for this article. The long cable and small holder matter in different ways: consider the route of the suspension as well as the space needed for its lower end. The 8 cm width should not be read as the size of a shade you might select for the finished arrangement.

Check additional components against the CAMELEON CABLE GX53 family before assembling your selection. A shared system name does not establish that every combination is compatible. The restrained beige finish and simple circular form suit modern, minimal compositions, while the appearance of the completed light will depend on all the parts chosen.

One replaceable GX53 light source

The holder takes one GX53 LED bulb rated at no more than 15 W. A bulb is not supplied, so it must be selected separately. That 15 W figure is a permitted maximum, not the consumption of a particular bulb or a measure of brightness. Light colour and luminous output depend on the source you install; compare those specifications when choosing it. A compatible bulb can later replace the original without replacing the suspension itself.

Package contents and use

The manufacturer lists the suspension and instructions as the package contents. When planning a complete light, do not assume that the photograph is an inventory of every mounting component you will need. This part is intended for indoor use, not a garden installation or a location exposed to moisture.

Electrical connection should be carried out by an appropriately qualified person with the power disconnected. Clean only after switching off and allowing the part to cool, using a lightly damp cloth. Keep moisture away from connections and allow everything to dry before switching on again.