SLV 1006133 LED power supply 24 V 60 W, 2-channel DALI-2 Tunable White, white

The SLV 1006133 is a two-channel, 24 V LED power supply for Tunable White systems, with DALI-2 and TouchDIM control. Its elongated white polycarbonate housing has covered connection areas at both ends. This is a component of a lighting installation, rather than a complete light fitting.

Match the supply to the LED modules

The output delivers a constant 24 V DC SELV voltage. Connected LED modules must therefore be designed for that supply; modules requiring constant-current operation are not interchangeable. The two channels support Tunable White, where white-light colour temperature can be varied. The power supply itself does not establish the colour-temperature range or luminous output of the connected modules.

For article 1006133, SLV specifies a load range of 5–60 W and a maximum output current of 2.5 A. The 60 W rating applies to the whole supply, not to each channel separately. Check the combined load and intended wiring arrangement of your selected LED modules before ordering.

DALI-2 and TouchDIM control

The control input supports DALI-2 DT8 and TouchDIM. In TouchDIM operation, the LED output provides a DimToWarm function. There is no DALI bus power supply inside this unit, so the control-system design must account for that separately. Leading-edge and trailing-edge phase dimmers cannot regulate this driver; an ordinary phase dimmer is not a substitute for DALI control.

Allow space for mounting and wiring

The housing measures 20.2 cm long, 5.8 cm wide and 3 cm high. Compare those dimensions with the intended installation space, allowing for cable routing and heat dissipation. The manufacturer's instructions limit the output cable length to 2 m and require installation by a qualified electrician.

When mounted outside a luminaire, the driver must be secured through its screw holes and the cables held correctly in the strain reliefs. The mains input is 220–240 V AC at 50–60 Hz. All LED modules must be fully connected with correct polarity before switching on; the output does not provide reverse-polarity protection.