The STEINEL L 270 digi SC is an outdoor LED wall light with an illuminated house-number panel. Its anthracite aluminium body and opal cover form a plain rectangular fitting. It combines entrance lighting with address identification, while the concealed motion sensor avoids a separate sensor housing on the facade.
Position the house number on either side
The complete fitting measures 36.6 cm wide, 23.5 cm high and 6.5 cm deep. Compare these dimensions with the available wall space beside your door. The large and small illuminated panels can swap sides, placing the number to the left or right of the light. Both panels, brackets, a sheet of adhesive house numbers and mounting accessories are included, so a separate number plate is not required.
This light is intended for outdoor wall mounting. Its IP44 rating provides protection against splashing water, and the manufacturer recommends an optimum mounting height of 2 m. It requires a 220–240 V mains supply; connection must be carried out by a qualified electrician.
Warm white light without choosing a bulb
The integrated LED system is included, so there is no bulb to buy. It delivers 637 lm at 3000 K, giving warm white light around the entrance and house number. The opal cover conceals the LEDs, and soft start raises the brightness gradually rather than switching straight to full output.
Neither the LED source nor the control gear is replaceable. When the source reaches the end of its life, the complete fitting must be replaced rather than an individual bulb.
Adjust three sensor zones in the app
The infrared sensor covers 180° and detects movement up to 8 m away. Each of its three zones can be disabled and have its range adjusted separately, helping exclude movement beyond the entrance. The STEINEL Connect app also sets the lighting duration from 5 seconds to 60 minutes and the twilight threshold from 2 to 2000 lx.
Adjustable basic and main light separate low-level illumination from the response to movement. Bluetooth Mesh allows compatible fittings to connect wirelessly; configuration requires a Bluetooth-enabled smartphone or tablet.