Maytoni Baker Street O021FL-L10B3K LED garden bollard, black, 80 cm, IP65 Promo Code - MAY20 until the end of Oct 31

Maytoni Baker Street O021FL-L10B3K is a black LED garden bollard standing 80 cm high. Its aluminium structure forms a narrow rectangular frame, with a bright light-emitting section beneath the top edge. The open centre distinguishes it from solid-bodied bollards and more traditional garden lanterns.

Allow for the footprint beside your path

Both width and length are 18 cm. Measure that space beside the paving and compare the height with surrounding planting before choosing a position. The light-emitting section should not disappear behind shrubs. At 80 cm, this is a low-level landscape fitting rather than a tall lamp post intended to illuminate an area from overhead.

The installation drawing shows the base fixed to the supporting surface, with the electrical connection made in the base area. This is a permanently installed fitting, not a portable patio lamp. Plan its position together with the power supply route, outside the usable width of the walkway. Check the actual footprint rather than relying on the slim appearance in a photograph.

A fixed warm-white LED output

The integrated LED source is rated at 10 W, with a colour temperature of 3000 K and a declared luminous flux of 520 lm. Its warm-white colour can be coordinated with other outdoor fittings specified at 3000 K. The light source forms part of the fitting, so there is no separate screw-in bulb to choose for this version.

Maytoni specifies a 180° beam angle and states that the fitting is not dimmable. Select the spacing between bollards for the particular path and intended lighting result; the lumen figure alone does not promise uniform illumination across an entire garden.

An open frame for outdoor settings

The IP65 rating supports outdoor use beside garden paths, terrace edges and building approaches, including hotel or restaurant grounds. Straight uprights, a square footprint and the black finish suit modern, modernist and minimalist layouts. The fitting requires a 220–240 V AC, 50 Hz supply. It is protection class I and requires a protective earth connection.