Lampshade CAMELEON ZENITH S cone lamp shade 20 cm grey blue 11506 Nowodvorski Promo Code 🚀- NOVO15 until the end of Oct 25

CAMELEON ZENITH S is the shade alone — a lacquered steel cone 20 cm across, in a matt grey-blue that Nowodvorski codes as P030 in its palette. There is an opening at the tip of the cone for the cord and its lampholder to pass through. It is a component of the CAMELEON system, not a finished lamp.

What is in the box and what you have to buy separately

The manufacturer states the package contents plainly: the shade and an instruction sheet. There is no cord, no lampholder, no ceiling box and no lamp — in the CAMELEON system a working pendant is four separate order lines.

The suspension that fits this shade is the CAMELEON CABLE GU10, a cord ending in a GU10 lampholder; the maker offers it from 1.5 to 7 m and in several finishes. A ceiling box and the mounting accessories that route the cord along the ceiling complete the set.

What light it gives

The CAMELEON suspension with a GU10 holder is specified by the manufacturer as max 10 W and for LED lamps only — filament and halogen GU10 reflectors must not be used in it. You choose the lamp separately, so the colour of the light follows that choice.

The cone is opaque and narrows towards the top, so all the light goes downwards in a tight pool. At 20 cm across this is a fitting for lighting one spot — a worktop, a section of a table — rather than a whole room, which is why shades from this family are usually hung several side by side.

Dimensions and build

The shade is 20 cm across at the lower edge and 14 cm tall. Compare that diameter with the width of the surface it will hang over, and with the spacing you want between shades if you are planning a row.

The body is lacquered steel and weighs 0.3 kg, 0.51 kg with its packaging — a mass at which the strength of the suspension is not a concern. The P030 colour reference lets you order the cord and the ceiling box in the same tone, because every part of the system carries the same palette number. The manufacturer specifies indoor use only; the shade is made in Poland, in Siemianowice.

Choosing CAMELEON components

This lampshade is a separate system component. To build a light, choose a compatible pendant cable with lamp holder, a suitable ceiling canopy or an adapter intended for your arrangement, and the mounting accessories needed to route the cable. The remaining components are selected separately.

For this shade, the manufacturer specifies these assembly options: CAMELEON CABLE GU10 — max 10 W LED only. Choose one suitable pendant cable; the listed families are alternatives.

When choosing a bulb, use the lower of the wattage limits specified for the shade and the selected pendant cable. The same bulb base alone does not establish compatibility; the full pendant-cable family designation matters.