LUMINES FLEXA LED kit 22-0101-73, anodized silver, 2.02 m, 24 V 20 W, 3000 K, IP68

LUMINES FLEXA 22-0101-73 is a prepared linear LED kit, combining an anodized silver aluminium profile with an LED strip and power leads. The strip is sealed in polyurethane resin using SealFlow® technology, and the completed fitting has an IP68 rating. This is not an empty channel that still needs a separately selected LED strip.

A 2.02 m section for surface or suspended mounting

This variant is 2020 mm long, with a 16 × 16 mm profile cross-section. Allow for the full 2.02 m when checking the installation space rather than treating the rounded 2 m description as an exact measurement. The manufacturer specifies surface-mounted or suspended installation, so the fixing arrangement can be planned around the intended light line and mounting surface.

Black leads emerge through the back of the profile at both ends, with 2 m of cable on each side. Their exit points are sealed. Plan the cable route alongside the fitting position; these leads are not an extension of the illuminated profile length.

Initial 3000 K versus the sealed light output

The variant designation refers to the strip's initial colour temperature. The FLEXA datasheet gives 3819 K after sealing for this configuration. When matching other lights, do not assume that the finished kit produces exactly 3000 K. The same data specifies 522 lm for a 1 m section and Ra 89 after sealing. That per-metre figure is not a declaration of the complete kit's luminous flux.

Kit contents and the power supply position

The listed contents are the FLEXA profile, a PROFI 24 V strip and OMYp / H03VVH2-F 2 × 0.5 mm² cable. This variant is designated 20 W. Space for a power supply must be planned outside the profile; the 24 V rating does not permit direct connection to a 230 V mains supply.

The narrow silver section and simple line suit modern, minimalist schemes. Consider it for decorative lighting in a living room, bedroom, corridor or commercial interior. Selecting this kit does not replace task-lighting design or the choice of suitable mounting and power components.