The LUMINES X end cap, article 12-0083-01, closes the end of an LED profile from the X system. It is made from ABS plastic in the inox finish and has a solid front without a cable hole. The finish name does not mean that the cap is made from stainless steel.
Choose the closed end for your X profile
This version is intended for an end where the power cable is not routed through the cap. Check both the X system designation and your planned cable route before choosing the end fitting. The manufacturer distinguishes between caps with and without a hole; this article number identifies the latter.
The rear view shows the projecting tabs that fit into the profile. Its front follows the profile's cross-section, closing the open end rather than acting as a diffuser along the full length.
A component, not a complete light fitting
This listing is for the end cap, not the profile or an assembled luminaire. The LED strip, SLIM cover and mounting clip are shown as separate components in the manufacturer's X system assembly diagram. Selecting those parts depends on the installation you are building.
Add your comment about LUMINES X inox ABS LED profile end cap without hole