Lillehammer 2263GR is an outdoor wall light shaped as a rectangular block of cast aluminium, powder-coated in graphite (RAL 7016). Seen from the front it is 8 cm wide and 18.5 cm high, and it projects 11 cm from the wall. The light source sits behind clear safety glass sealed with a silicone gasket.
What light it gives
The narrow optic sends out two beams of just 4°, one straight up and one straight down. They draw two thin, sharp lines of light on the wall, so this is a decorative facade effect rather than lighting for the surroundings. Half of the light goes upwards (ULOR 50 %), which is why the streak above the fitting is as visible as the one below it.
The Cree LED module produces 1008 lm, but the optic concentrates it into such narrow beams that the manufacturer gives 26 lm for the whole luminaire at 9 W, or 2.9 lm/W. The low figure comes from the light distribution, not from the output of the module: the light does not spill sideways but stays on the line. At 2700 K the light is warm and slightly yellow, close to a traditional bulb.
Mounting and connection
The light is fixed to the wall through two ø5 mm holes spaced 45 x 130 mm, following the installation instructions supplied with it. The terminals take conductors up to 5 x 1.5 mm², and the fittings can be looped through, so one supply can feed several lights along a facade. The cable enters through an EPDM gland and should be round, with an outer diameter of 7 to 10.5 mm.
The fitting is protection class I, so it must be connected to a protective earth conductor. IP65 means it is dust-tight and protected against water jets from any direction, so it can be mounted on an exposed facade without a canopy; IK08 rates its resistance to impact.
DALI2 control and servicing
The built-in electronic driver works with DALI2 control. Dimming, groups and scenes are set from a DALI controller. The LED module is included, so no separate light source has to be bought.
The light source (LED only) and the control gear are replaced by a professional service; the manufacturer offers repair kit ZS2263zx0009 for this. The driver is rated for 50,000 hours. Norlys designed Lillehammer 2263GR for lighting walls, facades and other outdoor architectural features.