Lillehammer 2264GR is an outdoor wall light shaped as a rectangular block of cast aluminium, powder-coated in graphite RAL 7016. Seen from the front it is 8 cm wide and 18.5 cm high, and it projects 11 cm from the wall. The light source sits behind clear safety glass sealed with a silicone gasket.
What light it gives
The narrow optic sends out a single beam of just 4°, straight down. It draws one thin, sharp line of light on the wall below the fitting, so this is a decorative facade effect rather than lighting for the surroundings. Nothing is emitted upwards (ULOR 0 %), so the light does not brighten the sky above the house.
The Cree LED module produces 504 lm, but the optic concentrates it into such a narrow beam that the manufacturer gives 13 lm for the whole luminaire at 4.5 W, or 2.9 lm/W. The low figure comes from the light distribution, not from the output of the module: the light does not spill sideways but stays on the line. At 2700 K the light is warm and slightly yellow, close to a traditional bulb.
Mounting and connection
The light is fixed to the wall through two ø5 mm holes spaced 45 x 130 mm, following the installation instructions supplied with it. The terminals take conductors up to 5 x 1.5 mm², and the fittings can be looped through, so one supply can feed several lights along a facade. The cable enters through an EPDM gland and should be round, with an outer diameter of 7 to 10.5 mm.
The fitting is protection class I, so it must be connected to a protective earth conductor. IP65 means it is dust-tight and protected against water jets from any direction, so it can be mounted on an exposed facade without a canopy; IK08 rates its resistance to impact.
DALI2 control and servicing
The built-in electronic driver works with DALI2 control. Dimming, groups and scenes are set from a DALI controller. The LED module is included, so no separate light source has to be bought.
The light source (LED only) and the control gear are replaced by a professional service; the manufacturer offers repair kit ZS2264zx0009 for this. The driver is rated for 50,000 hours. Norlys designed Lillehammer 2264GR for lighting walls, facades and other outdoor architectural features.