SLV OCULUS PD 1004673 is a white LED pendant with a small cylindrical aluminium body and glass optics. Its single light head measures just 9 cm in diameter and height, suspended from a slender cable rather than enclosed in a broad decorative shade. The plain cylinder suits modern and minimalist interiors where a compact fitting is preferred over an elaborate overhead feature.
Choose a defined or diffused light pattern
The lens optics produce a distinctly outlined lighting effect. A frosted disc is included to change that distribution to a more diffused result. This gives a practical choice between emphasising a selected surface and reducing the definition of the illuminated area, without changing the pendant body. The specified beam angle is 100°.
The integrated LED operates at 11 W, with a stated luminous flux of 35.6–780 lm and colour temperature of 2000–3000 K. Dim-to-Warm makes the light warmer as it is dimmed; it is not a separate colour-selection switch. Control requires a compatible trailing-edge phase dimmer. Check the dimmer's minimum load as well as its compatibility before specifying the installation.
Plan the drop around the furniture
The connection cable is 250 cm long. This is distinct from the 9 cm light-head height, so compare both measurements with the ceiling and the intended table or kitchen-island position. The compact downward-facing fitting can provide a local accent over a surface, in a living-room seating area or beside a bedroom zone. It should not be assumed to supply all the light a room needs. SLV also specifies accent-lighting uses in hotels, cafés, restaurants and professional practices.
Connection and maintenance
The cable has an open end. Installation calls for a suitable ceiling rose or compatible track adapter, which must be considered when completing the lighting arrangement. Electrical work requires an approved electrician. The LED source and control gear are replaceable by a professional rather than changed like an ordinary screw-in bulb. For cleaning, disconnect the power and allow the fitting to cool, then wipe only its exterior with a cloth lightly moistened with water.
