The Steinel LS 150 is an LED floodlight with a white aluminium housing and a rectangular head behind clear glass. This is the version without a motion sensor – listed as LS 150 M in older Steinel documents – and it is switched on and off with an ordinary wall switch. The LEDs are built in, so there is no bulb to buy.
How much light it gives
Drawing 14.7 W, the floodlight produces 1375 lm, roughly 94 lm per watt. According to Steinel, that output covers an area of up to 150 m² – a driveway, a yard or the wall of a building. The beam angle is 51°, and a ceramic reflector directs the light forward.
At 4000 K the light is neutral white, without the yellow tint of a traditional bulb and without a cool bluish cast. A colour rendering index of Ra 80 is typical for outdoor lighting: the colours of a car or plants remain recognisable, though less saturated than in daylight. The floodlight is not dimmable.
Mounting and aiming
The floodlight is 178 mm high and 157 mm wide, projects 167 mm from the wall and weighs 0.81 kg. It screws to the wall, and the fixings are included. For mounting on the corner of a building, so that the light covers the area in front of two walls, Steinel offers a corner bracket sold separately.
The head turns 80° horizontally and tilts 150° vertically, so the beam can be aimed at a chosen part of the driveway or down along the facade. The luminaire is protection class I, which means it must be connected to a protective earth conductor.
Where it can be used
IP44 means protection against splashing water from any direction, so the floodlight can be mounted on a facade, above the front door, on a terrace or balcony, and in an underground garage or car park. Steinel specifies an ambient temperature range of −10 to +30 °C. Impact resistance is IK03, which is low – the luminaire is best mounted out of reach.
Steinel states an LED lifetime of up to 50,000 hours, about 30 years at 4.5 hours of use a day. The light source cannot be replaced – at the end of its life the whole floodlight is replaced.