LUMINES DUAL LED set 24 V 60 W 2300 K IP68, silver, 3 m

LUMINES DUAL 22-0101-70 is a linear LED set built into a silver-anodised aluminium profile. Its nominal length is 3 m, with two parallel rows of LED strip inside. End caps and connection cables are included, so this is a populated lighting assembly rather than an empty channel awaiting a separate strip.

Understanding the 2300 K designation

The manufacturer's variant name specifies 24 V, 60 W and 2300 K. The photometric sheet makes an important distinction, however: the strip starts at 2300 K, while the measured colour temperature after sealing is 2784 K. Use the latter figure when comparing the finished light line with other lighting rather than assuming the name describes its final measured output.

The same sheet gives Ra 94 and 1210 lm for a one-metre section of this strip in the DUAL profile. That is a per-metre reference, not a declared lumen figure for the complete three-metre assembly. The manufacturer identifies decorative lighting as its intended function.

Allowing for end caps and cable runs

The aluminium profile is 3000 mm long, while the assembly drawing shows 3004 mm including its ends. Compare the overall measurement with the available mounting space, especially where the line will sit between fixed boundaries. A 2 m cable exits each end of the profile.

The documented contents are the silver DUAL profile, PROFI 24 V LED strip, grey 2-in-1 end caps and black OMY 2 × 0.75 cable. The cable's 230 V designation does not make this a mains-voltage LED set: the assembly operates at 24 V. Space for the power supply is required outside the profile.

A sealed surface-mounted light line

SealFlow® polyurethane resin seals the strips, and the manufacturer specifies IP68. Surface mounting keeps the profile on the mounting plane rather than requiring its whole body to be recessed. Straight edges and narrow silver borders suit modern, minimalist schemes. The manufacturer permits cutting to length; a shortened section needs the appropriate CAPO DUAL end caps and a properly sealed termination.