The Asker 1336GR is a 55 cm bollard shaped like an inverted L: a rectangular column 11 cm deep turns into a horizontal arm at the top, giving an overall width of 20 cm. The cast-aluminium body is powder-coated graphite (RAL 7016). The LED module shines from beneath the arm through a clear, textured, UV-stabilised polycarbonate diffuser, with the motion-sensor lens beside it.
Motion sensor and how it lights
A built-in PIR sensor with a dusk switch turns the light on when someone approaches, and only after dark. It leaves the factory set to maximum range, 1 minute of light after the last movement and a 10 lx dusk threshold; movement within range keeps it on. The fitting works on/off and is not dimmable.
It delivers 585 lm at 9.7 W in 3000 K, a warm white. The light is diffuse and aimed downwards onto the ground around the bollard – the ULOR is 0%, so none of it goes into the sky.
Installation and connection
The bollard is bolted down through four ø8 mm holes on an 18 × 50 mm pattern. Concrete-in (1907ZX0009) and ground (1908GA0009) anchors and mounting adapters are sold separately. The terminals take conductors up to 4 × 4 mm² and allow further fittings to be looped through. With an inrush current of 2.98 A, the manufacturer states that a B 10 A breaker can take 144 of these fittings and a B 16 A 230, so a long row of bollards along a path can run from one circuit.
Durability and service
The IP65 rating means it is dust-tight and protected against water jets, and IK10 is the highest common impact-resistance class. The fitting is protection class I, so it must be connected to a protective earth. The LED module is rated L70 above 50,000 h; the module and the sensor are replaced by a professional service, and Norlys supplies service kits for both. The bollard weighs 2.93 kg, and its plain angular form is a modern design.
Add your comment about Norlys Asker 1336GR LED bollard light with PIR motion sensor, graphite RAL 7016, 9.7 W 3000 K, 55 cm