NORLYS Lillehammer 2261GB outdoor wall light, beige grey RAL 7006, 2700 K LED up and down

NORLYS Lillehammer 2261GB is an outdoor wall light shaped as a vertical rectangular block, finished in beige grey RAL 7006. Its smooth cast-aluminium body and undecorated front create a modern, minimalist form. Light leaves the housing at both the top and bottom.

Two broad beams beside the façade

This version directs light 60° upwards and 60° downwards. When planning the arrangement on a wall, allow space for both beams above and below the fitting. Compare its proposed position with the windows, cornices and other features of your own façade.

The 2700 K colour temperature gives warm, slightly yellowish light. The complete fitting delivers 207 lm while drawing 7.6 W; this is the output after the optical system. When comparing several fittings, consider that complete-light output together with the beam direction and intended mounting height. Wattage alone does not describe the amount of light leaving the fitting.

Size and the beige grey finish

The housing is 18.5 cm high, with an 8 cm wide front and an 11 cm projection from the wall. Use these dimensions to check a narrow strip of render and the clearance beside a passage. GB denotes beige grey paint on aluminium, with RAL 7006 providing the colour reference when coordinating the fitting with a façade.

The housing is powder coated. Transparent safety glass closes the light openings, while the seals include silicone and an EPDM cable gland. IP65 allows the light to form part of an outdoor installation in accordance with the mounting instructions.

Included LED and DALI2 control

The LED source and driver are included, so there is no separate bulb to choose. Brightness is controlled through DALI2; plan suitable controls and wiring if you intend to use that system. A professional service can replace the LED module and control gear.

Protection class I requires a protective earth conductor. Two Ø5 mm fixing holes follow a 45 × 130 mm arrangement. Before preparing the wall, check the instructions, connection position and space needed for the housing.