NORLYS Molde DC1899BL black LED garden bollard 80 cm 2700 K 24 V DC

NORLYS Molde DC1899BL is an 80 cm LED garden bollard with a rectangular upright and a head curved over its light-emitting surface. This black RAL 9005 version has a powder-coated cast-aluminium body. Its plain outline and shielded light face give it a modern, minimalist appearance consistent with Scandinavian design.

Warm light beside paths and terraces

Two LED modules use a total of 7.2 W and produce warm-white light at 2700 K. The complete luminaire delivers 435 lm, whereas the light sources themselves produce 1024 lm. When comparing finished garden lights, use the luminaire output rather than treating the module figure as the amount leaving the fitting.

Norlys identifies gardens, terraces and paths as uses for Molde. Its diffused light is shielded from above and illuminates the area beside the bollard. Spacing between several fittings should follow the actual surface and lighting design, rather than an assumed coverage distance that applies everywhere. The 80 cm height also lets you compare the head position with neighbouring planting or the terrace edge before ordering.

A separate 24 V DC power supply is required

This is a low-voltage version, not a fitting for direct connection to 230 V mains. It needs an external constant-voltage 24 V DC power supply. The LED modules support dimming, but the control arrangement depends on the installation design and a suitable power supply. Norlys requires supply selection and installation to be carried out by an appropriately qualified person.

The LED light sources are part of the fitting. Replacement is a professional service operation, rather than a routine bulb change in a socket.

Plan the mounting as well as the wiring

Overall dimensions are 80 × 16.5 × 11 cm. The transparent, structured polycarbonate cover is UV-stabilised, and the fitting is rated IP54 and IK07. Mounting uses four 7 mm holes with 18 × 50 mm spacing.

Fixing screws are not included. Ground anchors and mounting adapters are purchased separately and should be chosen for the mounting surface in accordance with the Norlys instructions. Before ordering, establish both how the bollard will be secured and where its external power supply will be installed.