CRISEIDE S/1G FCRSO9 Pendant Light, Brushed Gold, Gea Luce

Gea Luce CRISEIDE S/1G FCRSO9 is a pendant light built around a single broad aluminium ring in brushed gold. A white opal silicone diffuser follows the ring, with fine suspension lines leaving its centre open. The absence of arms and separate shades gives it a geometric outline suited to modern and minimalist interiors.

Allow space for a 966 mm ring

Before choosing its position, compare the ring diameter with the width of your dining table or kitchen island. At almost one metre across, it occupies a substantial footprint even though the ring profile is only 46 mm high. Above a table, that open circle defines the dining area without introducing a solid shade across the view. It can also be considered for a living area or above tables in a restaurant or shared hotel space, subject to the available dimensions.

The manufacturer's drawing specifies a maximum overall height of 3000 mm. The cylindrical ceiling canopy measures 85 mm in diameter and 205 mm high. Installation planning therefore needs to account for both the ring's width and the distance from the ceiling to its lower edge. The maximum overall height does not, by itself, establish the clearance above a particular piece of furniture.

Integrated light in two directions

The built-in 100 W LED source produces warm white 3000 K light. Gea Luce specifies 5200 lm for this gold version and a diffuse 360° distribution. Light is emitted upwards and downwards, with the opal silicone forming a continuous line around the ring rather than a narrow spotlight beam. The source is integrated into the fitting, so there are no separate screw-in bulbs to select.

Plan the controls before installation

Phase-cut dimming and Push control are supported. The external dimmer and push button are not included; compatibility should be checked before wiring the installation. This indoor fitting operates on 220–240 V AC. Its instructions require installation by qualified personnel and disconnection of the mains before work on the light. For cleaning, the manufacturer recommends a damp cloth with mild detergent, followed by gentle drying with a soft cloth. Cables and electrical components must not be exposed to water or detergent.