Endon Burley 110459 Rechargeable LED Wall Light, Aged Brass, 1.5 W

Endon Burley 110459 is a rechargeable wall light with a circular wall plate, a short arm and an exposed LED light source. Its steel components have a brushed aged-brass plated finish. There is no power lead to connect while the light is in use, although the fitting still needs secure mounting and regular USB charging.

Match brightness to battery runtime

The integrated 1.5 W LED produces warm white light at 2700 K. Touch the button to cycle through 40, 80 and 155 lumens; a fourth touch switches it off. These are three defined brightness settings rather than continuous dimming through a separate wall control.

Endon specifies runtimes of 36, 18 and 10 hours respectively after a full charge. The longest figure therefore applies to the lowest setting, not maximum brightness. Burley provides supplementary light for a living room, bedroom or hallway. At a maximum of 155 lumens, it is best understood as a local light accent rather than the sole light source for an entire room.

Charging and what is supplied

The rechargeable 3.7 V, 3600 mAh battery and a USB-A-to-USB-C charging cable are included. Charging a fully discharged battery takes approximately 5.5 hours. The instructions require a 5 V, 1 A USB supply rated at no more than 5 W, advise against using the lamp while charging and require disconnection afterwards. The indicator changes from red to green when charging is complete. Neither the battery nor the LED source is replaceable.

Classic detail without a fabric shade

The fitting measures 19.4 cm high and 11 cm wide, with a projection of 16.6 cm. Compare that projection with available clearance beside a passage or shelf before deciding where to mount it. The circular backplate and aged metal finish suit classic and vintage interiors. A decorative 16 cm clip-on shade can be selected separately; it is not included with this fitting-only variant. Endon also identifies shelving as a possible mounting location. The instructions restrict use to indoor areas and expressly exclude bathrooms and outdoor locations. Clean the plated finish with a soft, dry cloth and avoid abrasive cleaning products.