NORLYS Rena 1551ST is a square drive-over ground light with a stainless steel faceplate and clear safety glass. Once recessed, its visible outline is a metal frame around a circular light opening. This restrained geometry suits modern paved layouts without introducing an upright bollard.
A concentrated accent from ground level
This version uses a GU10 LED source with a warm white colour temperature of 3000 K. The complete luminaire delivers 294 lm, whereas 375 lm describes the source alone. Keeping those two figures separate matters when comparing the output of different fittings. Its symmetrical 36° beam provides a concentrated accent rather than broad, diffuse illumination across an entire paved area. A CRI of 90 describes colour rendering on illuminated surfaces.
The fitting draws 5.5 W and supports both Trailing Edge and Leading Edge phase dimming. Any dimmer must be compatible with the LED source in use. During the warranty period, the manufacturer requires bulb replacement to be carried out only by its authorised service team or the manufacturer itself.
Drive-over use is not unrestricted
Rena is intended for outdoor orientation lighting or use as a spotlight. The manufacturer permits vehicles with pneumatic tyres to pass over it and specifies a maximum load of 2000 kg. It must not be placed in traffic lanes where hard braking, acceleration or changes of direction would impose horizontal forces. Its IP68 rating does not replace the substrate preparation and drainage required by the installation instructions.
Allow space below the paving
The faceplate measures 13 × 13 cm and the luminaire is 15.7 cm high. Plan for the installation space as well as the visible square. The body is powder-coated cast aluminium with a silicone seal. The manufacturer's configuration includes an installation housing and a 1 m H05BQ-F 3G1 cable terminated with a THB.391.R4A.L connector. Other connection accessories must be selected separately to suit the installation.