ARGON MOHITO 704 is a round flush ceiling light made from painted steel and glass. Its textured black outer ring surrounds a silver interior, with the glass diffuser recessed above the ring’s lower edge. This version presents a dark housing from the side and a lighter inner surface when viewed from below.
35 cm diameter with a 13 cm height
The fitting measures 350 mm in diameter and 130 mm in height. It occupies a 35 cm circle on the ceiling, so compare that footprint with nearby cupboards and the swing of opening doors before installation. There is no long cable drop: the fitting stays within its low ring-shaped housing.
Argon identifies the MOHITO family for living rooms, bedrooms and hallways. The recessed glass covers the light sources from below rather than leaving the bulbs directly exposed. A plain circular form without arms or decorative pendants gives the fitting its modern character.
Choose two E27 bulbs separately
There are two E27 lampholders inside, and bulbs are not included. The installation manual specifies LED bulbs rated at no more than 15 W per lampholder. This is a limit for each bulb, not a fixed consumption figure for the complete fitting: actual power use depends on the two bulbs you install.
Check bulb dimensions as well as the cap. The manufacturer allows a maximum width of 50 mm and length of 105 mm, so an E27 cap alone does not confirm that a bulb will fit inside. Your bulbs determine brightness and light colour; this is not a fitting with an integrated LED module.
Ceiling installation and bulb replacement
The fitting is intended for indoor use and a 230 V supply. The manual shows three ceiling fixing points and a protective earth connection. Installation must be carried out by a qualified person with the power isolated. Net weight is 4.5 kg, which should be taken into account when selecting fixings for your ceiling construction.
For bulb replacement, the lower glass assembly is removed with a turning movement as shown in the manual. Both lampholders are therefore accessible without replacing the complete fitting.