Nordlux Oja 29 is a round LED ceiling light with a white diffuser and a removable chrome frame. It measures 30 cm across and just 2.5 cm high, sitting close to the ceiling rather than hanging into the room. The chrome frame is included; removing it leaves the fitting with an all-white appearance.
Three scenes from an ordinary switch
Moodmaker™ works through a normal wall switch. Its settings are full brightness at 4000 K, full brightness at 3000 K and a night-light mode at 20% brightness and 3000 K. This gives you a choice between a more neutral light, a warmer light and reduced evening illumination without changing the light source or adding a separate controller.
The fitting remembers the previous mode and has a reset function. This is not continuous dimming through an external dimmer: you choose between three defined scenes. Before ordering, consider whether switching among these fixed settings suits your preferred way of controlling the room's lighting.
A shallow fitting for indoor ceilings
The housing and diffuser are plastic. Chrome describes the frame's finish, rather than indicating an all-metal light. Its simple circular shape has no decorative arms, making it a restrained choice for modern and minimalist interiors and compatible with Scandinavian furnishings.
Oja can provide ceiling lighting in a living room, bedroom, kitchen or hallway. The manufacturer also identifies bathrooms and basements as suitable uses. It has an IP54 rating but is intended for indoor use only. For a bathroom installation, a qualified installer must assess the location against the applicable electrical zones and local requirements.
The light source and installation
The integrated 14.5 W LED is included, so there is no separate bulb to buy. Nordlux specifies 1600 lm and a lifetime of 30,000 hours. The source is not replaceable; the complete fitting must be replaced when it reaches the end of its life. Oja requires a fixed connection to a 220–240 V supply and uses a twist-lock mounting connection. Mounting screws are not included and must be selected to suit the supporting surface.