GOLF 8375 is a ceiling recessed downlight with a round white trim ring 8.3 cm in diameter. The lacquered aluminium body sits above the ceiling, and a glass element closes the fitting at the front. It goes into a 6.8 cm hole and is held there by two side springs.
Cut-out and space above the ceiling
The mounting hole is round and 6.8 cm in diameter — check this figure before buying, especially when replacing old downlights, because it decides whether the fitting will go into existing cut-outs. The overall height of the fitting is 10.5 cm, so there must be enough free space above the ceiling board for the body with its lampholder and cable.
The fitting is protection class I, so it must be connected to the protective earth conductor, and it runs on 220–230 V.
Ingress protection: bathroom and kitchen
The manufacturer states IP54/20. From the room side the front is IP54, meaning it is protected against dust and against water splashed from any direction — which is why the fitting suits a bathroom or kitchen, where steam and splashes reach the ceiling. On the ceiling-void side IP20 applies, so the space above the ceiling must stay dry. GOLF is intended for indoor use only.
Which bulb to choose
The GU10 lampholder takes one R50 lamp, i.e. one with a 50 mm reflector, of up to 15 W — and the manufacturer allows LED lamps only. No bulb is included, so you choose the colour and beam angle yourself: 3000 K is warm white and 4000 K neutral light, often chosen for bathrooms and kitchens. The same fitting is also available in black (GOLF 8376).